4/10/2024 0 Comments Flock macintosh lagacy downloadThrough a browser (or script) you then have access to all your clips. When you connect to the cloud through your home Wi-Fi network, search for the IP address of the dashcam. You can already do that with the 2.004 version (and probably older cloud versions). Take a copy of the file once you've done this, as the upgrade process will overwrite the one on the SDCard. If you want to pre-configure one it's best to take a note of your current settings, then after step 3 above, using the app set up the same config again as you had before. Keep in mind that although some settings are shared between v1.X and v2.X, they both use different config.ini files. If you want to bring in pre-configured settings you'll have to do the upgrade, eject the SDCard, plug it in to a computer and copy the config.ini file back on to it after the firmware upgrade. Whether you pre-configure a config.ini (as I did) or not, you'll now have default settings. Make sure your car is running so that power stays on throughout the process. * Plug the SDCard in to the device, and start it up. * Extract the "Blackvue" directory to the SDCard (so you have "E:\Blackvue"). * Plug in your current SDCard to the computer back take a copy of your SDCard:\blackvue\config\config.ini In case you haven't seen the steps before (they've been posted elsewhere, but it doesn't hurt to repeat): I installed it via computer as I was going from v1.X to v2.X. I didn't drive anywhere yet so I am hesitant to say anything about the actual video quality already.Īlso, I was looking for an option to disable to rear led, but it seems that is a DR650S-only option You can actually setup 3, but I only use 2 (Wi-Fi at home and Wi-Fi in the car, the Wi-Fi in the car is only available when the ignition is on) I was able to set 2 hotspots and that seems to work fine. Only the latest version of the Android app (2.02) is compatible with this firmware Recording bitrates (file sizes from 1 minute recordings): Because I had to reset the time zone, it formatted the SD card (as mentioned on the download page) However, it basically reset most of the options (including the time zone) except the cloud Wi-Fi network I prepared the SD card, including my config.ini. Note 3: This firmware is compatible with the new BlackVue C app only, as well as the BlackVue Windows / Mac Viewer. Note 2: To check if your BlackVue DR650GW-2CH / 2CH TRUCK dashcam is compatible with BlackVue Over the Cloud, refer to. Note 1: Even if you install this Cloud firmware, you will be able to install the Legacy firmware again. ※ When you change the time zone and save the settings, the next time you insert the microSD card into the BlackVue it will format the microSD card. – Windows viewer, Mac viewer (latest version embedded in the firmware folder)ġ) Added video quality settings (Highest/High/Normal). ※ Please be sure to update to the latest version of the following: Refer to the table for a comparison with the Legacy firmware (v1.xxx). The long awaited upgrade is out? So did it solve all the problems?īlackVue DR650GW-2CH (v.2.005_2016.07.12)Īlso compatible with BlackVue DR650GW-2CH TRUCK and DR650GW-2CH IR.įirmware compatible with the Cloud service – BlackVue Over the Cloud.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |